Driver Installation - for Packet Driver
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^
(1) Introduction:
-----------------
This document describes the procedure to setup the Packet driver for
ENW-9501 10/100Base-TX PCI Fast Ethernet Adapter.
(2) Location of Driver:
-----------------------
\PKTDRV\FEPD.COM
(3) Sample Configuration Files:
-------------------------------
%% AUTOEXEC.BAT %%
FEPD (Since the default software interrupt is 0x60 )
or
FEPD <PD_INT_NO> (Interrupt entry should be between 0x60 - 0x80)
(4) Notes:
----------
1. Load the packet driver using the software interrupt and any
optional switches if required.
Usage: FEPD [options] <software_int_no>
Example: FEPD -n 0x7e
2. Executing FEPD need no parameter. When identify the adapter, FEPD
will automatically sense the line speed (10Mbps or 100Mbps), read
configurations from PCI BIOS and give 0x60 as default software
interrupt number.
Software interrupt number is changable by user's favorite. Admitted
range is between 0x60 - 0x80.
Other options list below:
-fd Full-Duplex mode.
-n NetWare conversion. Converts 8137 packets to 802.3 packets.
-w Let packet driver run under windows.
-h Help
-u Unload the driver
3. Run FEPD.COM, the screen will appear following message:
PCI BUS (fast) Ethernet adapter Packet Driver v1.00 (951208)
(C) Copyright 1995-1996. All Rights Reserved
Performing Power-Up Autosense...
Switching between 10BaseTx and 100BaseTx...
Switching to 100BaseTx...
Ethernet Address is : (00:A0:CC:66:00:03)
Packet Driver Interrupt Number : 0x60
Hardware Interrupt Number : 5
Base I/O Address : 0xD000
Medium Type is : 100Mbps Tx
Packet Driver is loaded at segment : 29C2
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.