1. e3kit253.zip Driver
2. OEMSETUP.INF File Contents

OEMSETUP.INF Driver File Contents (e3kit253.zip)

;
;       EtherWORKS3/TURBO Setup files for Microsoft Windows for Workgroups
;       ISA Version
;
; NOTE: This oemsetup is for an EtherWORKS 3 module in ISA mode.
;       The NDIS3 driver supports ONLY ISA mode.
;       If you wish to use the NDIS2 or ODI drivers with a module in 
;       EISA mode, use the oemsetup file from the EISA subdirectory on 
;       the installation diskette.
;
[data]
type=network
version="1.0.006"

[disks]
y = .\ndis2\dos\, "Digital EtherWORKS3/TURBO",EWRK3, disky
z = .\wfw\,"Digital EtherWORKS 3/TURBO",EWRK3, diskz

[netcard]
;
; MSID = 0 (microsoft ID)
; type = ndis ---> ndis2 and ndis3 compatible
; media = ethernet
; mode  = 1 (ndis2) + 2 (ndis3) + 4 (ndis3 via odi mappers) = 7
;               (types of drivers)
; install = ewrk3 (file install info for this driver)
;               (maps to ndis3 mac section name in protocol.ini)
; protocol = ewrk3_nif (contains protocol.ini info for this driver)
;               (only applies to ndis2 and ndis3)
; 
DEC$EWRK3="DEC EtherWORKS 3/TURBO",0,ndis,ethernet,0x07,ewrk3_install,ewrk3_nif

[ewrk3_install]
ndis2=y:ewrk3.dos
ndis3=z:ewrk3.386
mlid=*:ewrk3.com

[ewrk3_nif]
;
; The 0x20 at the end of the parameter indicates that this applies
; to NDIS3 only.  These parameters will not be added for an NDIS2 driver.
;
DRIVERNAME=EWRK3$
IO=IOAddress,,hex,"0x100,0x3e0,32",0x300,0x20
param=MemoryMode,"Enhanced Memory Mode must be 32K",enum,"32k,0x20",0x20,0x20
irq=Interrupt,,enum,"5,5,10,10,11,11,15,15",5,0x20
mem=RAMAddress,,hex,"0xA000,0XF800,0x800",0xD000,0x20