AWCPKT.INI Driver File Contents (48dsk103.exe)
Driver Package File Name: 48dsk103.exe
;Initialization file for Infrastructure operating mode
SSID="tsunami" ;must match Access Point setting
;Following are some parameters that may be modified. For
;most situations the factory defaults will be appropriate.
;Any omitted parameter will assume the factory default.
;FragThreshold=2312 ;packet size to start fragmenting
;RTSThreshold=2312 ;packet size to start sending RTS/CTS
;DataRate1=0x02 ;(1) Mbps supported data bit rate
;DataRate2=0x04 ;(2) Mbps supported data bit rate
;DataRate3=0x0B ;(5.5) Mbps supported data bit rate
;DataRate4=0x16 ;(11) Mbps supported data bit rate
;RefreshInterval=10000 ;inactivity time to check association
;PowerSaveMode="CAM" ;Constant Awake Mode
;MaxPowerSave="OFF" ;Maximum power save mode
;NodeName="" ;descriptive station name
;The adapter needs 32 16-bit I/O ports, and 1 non-sharable IRQ.
;The following lines should be uncommented and the appropriate
;values set in the following scenarios:
; 1) PCMCIA mode: Override the I/O port base and/or IRQ
; assigned by PCMCIA card services.
; 2) PCMCIA mode: PCMCIA card services is not being used.
; 3) ISA mode: Override the I/O port base and/or IRQ assigned
; by Plug and Play.
; 4) ISA mode: Non-Plug and Play operation.
;If the PCMCIA interface is being used without PCMCIA card services,
;uncomment the following lines and set the appropriate values.
;If the PCMCIA interface is not being used, set the appropriate
;value of "ISA" or "PCI".