1. 370inf.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (370inf.zip)

                                 Triones
             Bus Master EIDE/ATAPI Device Drivers for Intel PIIX
                         OS/2 2.0 and WARP 3.X
                             Revision  3.22

                             (March 15,1997)

#############################################################################
NOTE:
    This version of driver doesn't support PIIX4 (TX) motherboards!

1   INSTALLATION
    1.  Copy TRIOS2.ADD from the floppy diskette to your hard disk under
        the OS2 directory (i.e., C:\OS2).
    2.  Edit C:\CONFIG.SYS  to  replace
            BASEDEV=IBM1S506.ADD
            with
            BASEDEV=TRIOS2.ADD
    3.  Reboot the system.

2   DE-INSTALLATION
    1.  Edit C:\CONFIG.SYS  and change
            BASEDEV=TRIOS2.ADD
            back to
            BASEDEV=IBM1S506.ADD
    2.  Reboot the system.

3   TROUBLESHOOTING
3.1 Overriding Drive Capabilities
    If the OS/2 system does not work properly after the installation,
    it could be that the device drives report wrong capabilities. The user
    can use parameters to override the capabilities reported by the
    connected device drives.

    The user can append parameters with the following format
        [/V] [/drive [dma=dmamode|pio=piomode] [!lba] [!ms]]
    to "BASEDEV=TRIOS2.ADD"
    Where
    V       indicates to display verbose information.
    drive   specifies which drive to override on.  It can be:
                PM  primary/master
                PS  primary/slave
                SM  secondary/master
                SS  secondary/slave
    dmamode specifies the overriding DMA mode. It can be:
                SW2 single word DMA mode 2
                MW1 multi-word DMA mode 1
                MW2 multi-word DMA mode 2
                NO  not use DMA operation. The PIO will be used.
    piomode specifies the overriding PIO mode. It can be:
                0   PIO mode 0
                1   PIO mode 1
                2   PIO mode 2
                3   PIO mode 3
                4   PIO mode 4
            If the pio_mode is specified, the driver will only use PIO
            operation on the corresponding drive.
    !lba    indicates not to use LBA mode.
    !ms     indicates not to use multi-sectors commands.



How To Update Drivers Manually

After your driver has been downloaded, follow these simple steps to install it.

• Expand the archive file (if the download file is in zip or rar format).

• If the expanded file has an .exe extension, double click it and follow the installation instructions.

• Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.

• Find the device and model you want to update in the device list.

• Double-click on it to open the Properties dialog box.

• From the Properties dialog box, select the Driver tab.

• Click the Update Driver button, then follow the instructions.

Very important: You must reboot your system to ensure that any driver updates have taken effect.

For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.