1. SiS900.zip Driver
2. README.TXT File Contents

README.TXT Driver File Contents (SiS900.zip)

            SiS PCI Fast Ethernet Adapter Installation
                     for Windows NT 5.0 Driver
            ==========================================

driver file:  .\sisnic.sys
INF file:     .\netsis.inf

Install The Driver
------------------

1.  Install the card in the PCI slot and connect the cable to the network;
    turn on the computer and start Windows NT.

2.  When Windows NT starts, a "Found New Hardware Wizard" dialog box appears
    identifying the card as a "Ethernet Controller";
    Select "Search for a suitable driver for your device [Recommended]".

    NOTE, if the "Found New Hardware Wizard" dialog box does not appear,
    Windows NT fails to detect your adapter. There may be problem with the
    adapter itself or with the system BIOS.

3.  Click Next then only enable the "Specify a location" check box;
    Insert the "SiS PCI Fast Ethernet Adapter Drivers Disk" in your drive A:
    or B:

4.  Click Next then specify correct driver path, e.g. A:\NT50 or B:\NT50;

5.  Click Ok then Windows NT will indicate that it will install the driver
    using A:(or B:)\NT50\NETSIS.INF

6.  Click Next to let Windows NT finishes the driver installation.


Adapter Configuration
---------------------

1. Double click "My Computer".
2. Double click "Control Panel".
3. Double click "System" icon.
4. Click "Hardware" tab then click "Device Manager..."
5. Open "Network Adapters" icon.
6. Double click
   "SiS 0900 PCI Fast Ethernet Adapter" or
   "SiS 7016 PCI Fast Ethernet Adapter"
   then a properties page appears.
5. Click "Advanced" tab.
6. Here, you can set the following properties:

   <1>. MediaType

             100BaseTX
             100BaseTX Full_Duplex
             10BaseT Full_Duplex
             10BaseT
             AUTO_CONFIG   ;Default value if not set

   <2>. NetworkAddress

             Override the adapter's Ethernet address. Legal values are
             xx-xx-xx-xx-xx-xx, where xx is a hexadecimal byte value.
             Unless necessary, do NOT modify this field and let the
             system use the default Ethernet address contained in the
             serial ROM on the adapter.


---End of File---