This program is intended to be used only with a PMAC2. While using this program, many I-, P-, and M-variables will be modified. Also, a few PLC and motion programs will be modified to perform necessary tests. Here is a list of the items what will be modified: Variables: P1000 to P1023 I10, Ix00 to Ix89 and I900 to I9n9 M100 - M1023 (not all, but several) Programs: PLC 11..18 and PLC 30, PLC 31 Motion program 999 Coordinate System definitions Also you will need the following information about your system while using this program: 1. Encoder counts per revolution of each motor (counts per inch in case of a linear motor). 2. Current ratings, continuous and instantaneous, for both the motors as well as the amplifiers. 3. If you have an induction motor the rated speed and rated frequency. 4. If you have a stepper motor the desired pulse frequency. Please be aware of this fact and make necessary backups with the PMAC Executive. Havefun! If there are any questions, please contact Delta Tau at (818) 998-2095.Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.