1. 2400r20.exe Driver
2. SCO5.TXT File Contents

SCO5.TXT Driver File Contents (2400r20.exe)

SCO UNIX 5.X
This is an ASCII file called SCO5.TXT in the ATI 
CardAssistant TXT\UNIX directory. Use a text editor or a 
word processor with a mono-space font such as Courier 
to print this file if needed for reference.
************************************************************
************************************************************
**                                                        **
**        Installing the AT-2400 Driver on SCO 5.x        **
**                                                        **
************************************************************
************************************************************

------------------------------------------------------------
--                        Contents                        --
------------------------------------------------------------
I.   Special Considerations 
II.  Files Needed for Installation
III. Installing the AT-2400 with SCO 5.x 


I. Special Considerations
=========================

This document describes the procedure to install the SCO 
UNIX driver for the AT-2400 Ethernet adapter.

Configuration of the AT-2400 is under PCI control. For most 
applications, no setup other than normal installation of 
the network software is necessary. To view the card's 
configuration or to run Diagnostics, use the CardAssistant 
setup program, SET2400.EXE. 


II. Files Needed for Installation
=================================

Location of Files: \SCO\5.X

The following files will be used in this installation:
------------------------------------------------------
vol.000     :  Installation Packet


III. Installing the AT-2400 with SCO 5.x 
========================================

Before you start with the installation process, make sure 
that the SCO UNIX system is properly installed. Similarly, 
your adapter should also be properly installed in your 
machine.

1. Log into the UNIX system as supervisor (root) and enter Maintenance mode.

    (Note: Make sure that the current directory is "/"
     using UNIX command - pwd.)

   Please follow the following steps to uncompress the package file:

   >  cd /tmp   (and insert the floppy in the proper drive, i.e. a:)
   >  doscp a:/sco/5.x/vol.000 ./VOL.000.000

   Now the installation directory is ready for use.

3. The following sections describe configuration of the driver.
   It is suggested that you should carry out these instructions in a
   singler-user environment.

   Run the custom utility and select the "Install new package" option.

   Select Media Type "Media Image" and type Image Directory "/tmp "
   It will prompt with "ATI AT-2400 PCI 10MB Ethernet Adapter Driver
   (ver 2.0.0)"

   After running the custom utility and the new package is installed,
   you should use the "netconfig" command to add the driver into your
   system as described in step 4 below.

4. Run "netconfig". Add the desired chain.

5. When the chain has been configured, select 'q' from the
   netconfig menu. and relink the kernel at the prompt.

6. To activate the adapter, you must reboot. When the system
   boots, you should see the following data dispalyed among the
   configuration messages:

    %ethernet  0xD800-0xD81F   11   -   type=100 addr=00-00-e8-xx-xx-xx
                               .
                               .
                               .


7. If you encounter any problems during installation,
   (i.e., an error message appears on screen) call your dealer for assistance.




*  Third-party trademarks are the property of their 
   respective owners.