1. 2400r10.exe Driver
2. RG58_CBL.TXT File Contents

RG58_CBL.TXT Driver File Contents (2400r10.exe)

10Base2 cable specifications
This is an ASCII file called RG58_CBL.TXT in the ATI 
CardAssistant \TXT\GENERAL directory. Use a text editor or  
a word processor with a mono-space font such as Courier 
to print this file if needed for reference.
************************************************************
**                                                        **
** Specifications and recommendations for 10Base2 cabling **
**                                                        **
************************************************************

BNC connector
=============

In addition to an RJ45 connector, the AT-2400 PCI Ethernet 
Adapter Card has a bayonnet nut couple (BNC) connector for 
10Base2 standard thin Ethernet RG58 coaxial cable (thinnet).


RG58 coaxial cabling
====================

The maximum segment length is 185 meters (606 ft.), and 
the minimum length between nodes is 0.5 meters (1.64 ft.). 

For more information on the 10Base2 specification, contact 
your local network supplier or call the IEEE at 
800-678-IEEE.

Recommended cable
-----------------

IEEE 802.3 10Base2 standard

Termination
-----------

Internal nodes on a segment should be connected to the 
thinnet cable via standard 10Base2 T-connectors. End-point 
nodes and only end-point nodes should be terminated with 
50 Ohm terminators. (As a default, Allied Telesyn 10Base2 
hubs offer 50 Ohm termination internally.) If the segment 
end does not have internal termination, use a T-connector 
and 50 Ohm barrel terminator.


Link integrity
==============

ACT light for activity

LNK light for link

Refer to the "Diagnostic LED" information file for 
brief description.

Note: The LED indicates read/write activity on the 
network, not necessarily activity on the adapter.


Common problems
===============

A hub can't detect a workstation
--------------------------------

This is often the result of a crossed wire in the cable or 
wiring closet. Make sure the wiring is correct.

Workstations can't connect to the network
-----------------------------------------

Reset or power off/on your hub or switch.



*  Third-party trademarks are the property of their 
   respective owners.