1. DE530CTP.EXE Driver
2. MSCLIENT.TXT File Contents

MSCLIENT.TXT Driver File Contents (DE530CTP.EXE)

D-Link Support Publishing       \NDIS\MSCLIENT.TXT              November 1996

                 D-Link PCI Family Ethernet Adapter Installation
                   for Microsoft Network Client 3.0 for MS-DOS

 Contents
 ÄÄÄÄÄÄÄÄ
     Introduction
     Requirements
     Minimum Skill Level
     Compatibility List
     Getting Started

 Introduction
 ÄÄÄÄÄÄÄÄÄÄÄÄ
    This installation assumes that the adapter is working properly.
    Getting Started will describe the installation instructions.

 Requirements
 ÄÄÄÄÄÄÄÄÄÄÄÄ
     A PCI compatible computer
     Microsoft Network Client
     A PCI Family Series Adapter
     A knowledge of basic DOS commands and editing text files

 Minimum Skill Level
 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
     A knowledge of basic DOS commands
     A knowledge of editing text files
     A knowledge of DOS basic file structure (CONFIG.SYS and AUTOEXEC.BAT)
     A knowledge of the network driver configuration being used


 Compatibility List
 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ
     Any PCI Family Ethernet Adapter
     For a Motherboard compatibility list please consult your local
      D-Link Branch Office

 Getting Started
 ÄÄÄÄÄÄÄÄÄÄÄÄÄÄÄ

 [Method 1]:

       Execute SETUP.EXE from Microsoft Network Client for DOS release
        diskette.

       Specify the <target path> which Microsoft Network Client for DOS
        files will been copy.

       Select "Network adapter not shown on list below ...".

       Please specify the location (path, C:\NDISDOS) of the OEM driver
        you want to use, press <Enter>.

       Select "D-Link PCI Ethernet Adapter".

       Select "Change Network Configuration", "Add Protocol" as you want.

       Follow screen instructions to complete the process. Simply
        pressing <Enter> for each screen display will select the default
        options. Press <Enter> until you reach the display prompting you
        to reboot your system.


 [Method 2]:

       Please Change to the Microsoft Network Client subdirectory,
        and run SETUP.EXE. (default directory is C:\NET)

       The screen will display some information. Press <Enter> .

       Responds to the screen prompts, selecting 
        "Change Network Configuration", then press <Enter>.

       Move the highlight to "Add Adapter", press <Enter>.

       Select "Network adapter not shown on list below ...".

       Please specify the location (path, C:\NDISDOS) of the OEM driver
        you want to use, press <Enter>.

       Select "Add Protocol" as you wish.

       Follow  screen  instructions  to  complete  the  process. Simply
        pressing <Enter> for each screen display will select the default
        options. Press <Enter> until you reach the display prompting you
        to reboot your system.