1. Driver.zip Driver
2. README File Contents

README Driver File Contents (Driver.zip)

****************************************************************************
*									   *
*			  PCMCIA Ethernet Adapter			   *
*									   *
*		    NDIS Driver for Windows NT v3.1/v3.5		   *
*									   *
*				 Ver. 3.00				   *
*									   *
*				README file				   *
*									   *
****************************************************************************

1. Introduction:

   This Ethernet NDIS driver conforms to Microsoft LAN Manager Network
   Driver Interface Specification (NDIS) Version 3.0, supporting Microsoft
   Windows NT v3.1 and v3.5 environments.


2. Contents of the Subdirectory:

      RETH.SYS	      The NDIS3 driver for Windows NT.

      OEMSETUP.INF    A setup-information file for installing the Ethernet
		      NDIS driver under Windows NT.


3. Installation

   First, install your PCMCIA Ethernet Adapter on your system following
   the procedure described in your installation manual.  Then follow the
   instructions listed below to load this driver on a Windows NT system.

   1) At DOS (not NT's DOS session), run ENABLER.EXE to enable your card.
      For information about ENABLER.EXE, see README under the directory
      \INSTALL of your PCMCIA Ethernet Driver Diskette.

   2) Warm boot (not cold boot) your system.

   3) If Windows NT operating system is being installed, select other
      manufacturers from the network adapter card options and follow
      step 7-11.

   4) If Windows NT operating system is already installed, logon as
      administrator and select Network icon from the Control Panel
      window.

   5) Select the "Add Adapter" button from the Network window.

   6) When network adapter choices appear, select "<other> Require
      disk from manufacturer" and then select the "Continue" button.

   7) Insert the distribution disk into drive A: or B:, and specify the
      path name where stores the Windows NT driver (e.g., A:\WINNT\3.X),
      if necessary.  If the driver is loaded successfully, the "Select
      OEM Option" window with PCMCIA Ethernet Adapter listed will appear.
      Press the OK button to continue.

   8) Follow the instructions appearing on the screen and select the appro-
      priate drive name (A:\ or B:\) when asked to give the source for the
      driver.

   9) Also select appropriate hardware setup of the Ethernet adapter. Note
      that the I/O base address and IRQ selected here must be consistent
      with those settings specified for ENABLER.

   1) Select OK from the Network window.

   2) Restart Windows NT.  If you perform cold boot, you will need to
      repeat Step 1 and Step 2 to use your PCMCIA Ethernet Card under
      Windows NT.