IBM TrackPoint Support for Windows 95/98 and Windows NT
=======================================================
This software is intended for use with the IBM PS/2 TrackPoint,
version 4.0. or later. For earlier versions, no special software
is needed.
Copy all the files associated with this driver to a freshly formatted 3.5
inch floppy. Insert the floppy into the A: drive of your OmniBook and
perform the following procedure.
1. If it has been installed, remove the touch pad driver.
2. From the Start menu, shut down, then restart the OmniBook.
3. When you see the HP logo, press F2 to enter the BIOS Setup utility.
4. From the System Devices menu, check Internal Pointing Devices and
select Pointing Stick or both.
6. Press F10 to Save and Exit the BIOS Setup utility.
7. Reset the OmniBook.
8. Windows 95 and Windows NT:
To install pointing stick support for Windows 95 and Windows NT:
from Control Panel open the Mouse applet, select the General tab
sheet, select Change, select Have Disk and point to the A: drive.
Select the IBM PS/2 Trackpoint driver and press OK. Close the Mouse
Properties dialog, remove the floppy disk from drive A: and restart
the OmniBook.
Windows 98:
To install pointing stick support for Windows 98: from Control Panel
open the System applet, select the Device Manager tab sheet, display the
Properties sheet of the current mouse device, select the Driver tab sheet,
select Update Driver, select 'Display drivers in a specific location', select
Have Disk and choose the A: drive. Press OK and select the IBM PS/2 Trackpoint
driver. Follow the prompts to copy the new driver files from the A: drive, and
restart the OmniBook when prompted.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.