1. FWConfig_v1.03.1.zip Driver
2. sample_config.txt File Contents

sample_config.txt Driver File Contents (FWConfig_v1.03.1.zip)

; Sample configuration file for INIC-2430 bridge.
; The file has the following format:
; 
; [section]
; key=string
;
; any line starting with a ";" is comment line


[Vendor Name]

VendorText=Initio


[Model Name]

MasterModelText=INI-T340
SlaveModelText=INI-T3401


[Firmware Control]

; VendorTextFrom control field takes two values:
; 0 means vendor text from ATA/ATAPI device
; 1 menas vendor text from the "VendorText" field above

VendorTextFrom=1

; ModelTextFrom control field takes two values:
; 0 means model text from ATA/ATAPI device
; 1 menas model text from either "MasterModelText" or "SlaveModelText" field above

ModelTextFrom=0

; ChipIDHiFrom control field takes two values:
; 0 means chip_id_hi takes the same value as the read-only product id of this chip,
; 1 means chip_id_hi is user defined value, usually as part of the serial number of the board

ChipIDHiFrom=0


[1394 Config ROM]

VendorID=001010
ChipIDHi=03
ChipIDLo=123456
ModelID=654321


[Hardware Control]

; The I/O modes here means the max I/O mode supported by firmware,
; not necessarily the max I/O mode supported by the device
; valid PIO mode is from 0 to 4
; valid DMA mode is from 0 to 2
; valid UDMA mode is from 0 to 6

MasterPIO=2
MasterDMA=2
MasterUDMA=5

SlavePIO=2
SlaveDMA=2
SlaveUDMA=5

; valid start_wait_time is from 2 to 35 seconds

StartWaitTime=2

; valid max payload is from 512 bytes to 4096 bytes, in multiple of 128 bytes

ReadMaxPayload=2048
WriteMaxPayload=2048