Window NT Installation:
1. Copy ICS_NTGPIB.exe to a temporary directory on your hard disk.
2. Run ICS_NTGPIB.exe
3. Run SETUP.exe
4. Shut down and install the PCI card.
5. Restart the computer.
6. Run CBCONF32.exe and select GPIB0, GPIB0 and selected card type (488-PCI or 488-PCM) and
Installed.
Note for PCMCIA:
Win-NT does not support "Plug-N-Play" in the sense of Win-95. For
PCMCIA interfaces, you must follow this install sequence:
a. Install the GPIB software.
b. Set the PCMCIA.SYS driver for "Auto" start-up.
c. Shut down your system.
d. Insert the PCMCIA card.
e. Re-boot your system. You should now see your GPIB card listed
under "PCMCIA" in the Control Panel. It should also have I/O
port and interrupt level resources assigned.
It is recommended that, if possible, you leave the short umbilical
cable attached when removing the PCMCIA card as it will reduce
wear and tear on the connector.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.