NetWare DOS ODI Workstation Driver Installation Guide
=====================================================
A.) Installation Procedure
==========================
Before you start with the installation process, make sure that the adapter is
properly installed and configured. Besides, make sure that your NetWare
operating system is properly installed. Before starting the following steps,
excute COPEN.EXE first
1. Execute the following commands in order.
COPEN
LSL
CNF301
IPXODI
NETX (or VLM)
2. You can now login to the server.
B.) Installation Notes
======================
1. Remember to specify LASTDRIVE=E in the CONFIG.SYS file if using the NETX
as DOS requester. (specify LASTDRIVE=Z if using the VLM)
2. Since different versions of Netware servers use different default frame
type, please make sure that both server & workstation are using the same
frame.
3. A typical NET.CFG is given below.
Link SUPPORT
Buffers 8 1514
Mempool 4096
Protocol
Bind cnf301
Link Driver CNF301
Frame Ethernet_802.2
Frame Ethernet_802.3
Frame Ethernet_II
Frame Ethernet_snap
IRQ=3
IOPORT=300
NWAY
;S10
;S10FD
;S100
;S100FD
4. If you want the driver to be run in a specific mode(Half/Full Duplex Mode),
what you need to do is to remove the semi-colon in front of the
corresponding mode (S10, S10FD, S100 or S100FD) in the NET.CFG file.
A typical NET.CFG example to run driver on 100Mbps Full Duplex mode is
given below.
Link SUPPORT
Buffers 8 1514
Mempool 4096
Protocol
Bind cnf301
Link Driver CNF301
Frame Ethernet_802.2
Frame Ethernet_802.3
Frame Ethernet_II
Frame Ethernet_snap
IRQ=3
IOPORT=300
NWAY
; S10
; S10FD
; S100
; S100FD
The default mode is NWAY. And actual transfer mode will be displayed while
loading the driver to indicate either Full-Duplex or Half-Duplex.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.