dmfe.c: Version 1.25
A PRO200 DM9102 fast ethernet driver for Linux.
This is a release version. It was developed on Linux kernel V2.0.34
and this developing environment was installed by RedHat 5.1. Even
verified on RedHat 5.1/5.2 and Caldera 1.6/2.2B.
gcc compiler version is V2.7 .
Compiler command:
"gcc -DMODULE -D__KERNEL__ -I/usr/src/linux/net/inet -Wall
-Wstrict-prototypes -O6 -c dmfe.c"
The following steps teach you how to active DM9102 board:
1. Used the upper compiler command to compile dmfe.c
2. insert dmfe module into kernel
"insmod dmfe" ;;Auto Detection Mode
"insmod dmfe mode=0" ;;Force 10M Half Duplex
"insmod dmfe mode=1" ;;Force 100M Half Duplex
"insmod dmfe mode=4" ;;Force 10M Full Duplex
"insmod dmfe mode=5" ;;Force 100M Full Duplex
3. config a dm9102 network interface
"ifconfig eth0 172.22.3.18"
4. active the IP routing table
"route add -net 172.22.3.0 eth0"
5. Well done. Your DM9102 adapter actived now.
Author: Sten Wang, (03)5798797-8517, E-mail: sten_wang@davicom.com.tw
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.