TAMARACK TC902X 10/100/1000 FAST ETHERNET ADAPTER
Packet Driver
Introduction:
This document describes the procedure to setup the Packet driver for
TAMARACK TC902X 10/100/1000 FAST ETHERNET ADAPTER.
Location of Driver: \PKTDRV\TC902XP.COM
\PKTDRV\TC902XP.SYS
Usage:
Two methods can be used:
METHOD 1:
---------
- If you want to use TC902XP.SYS program, the following statement must be
included in your CONFIG.SYS file:
DEVICE = TC902XP.SYS [/option] <packet_int_no>
<packet_int_no> Software interrupt number
/w Windows mode
/d Delay initialize
/u Uninstall driver
/n NetWare conversion
/tx_buffers Set tx buffer number.
/rx_buffers Set rx buffer number.
/delaycounts Set send packet delay count(micro sec).
/autosense Performs Power-Up Autosense on all types of
boards in order to connect to the active line,
and dynamic 10/100 autosensing (at run-time)
on boards supporting it.
/100BaseTXFD Select 100Mbps full-duplex mode.
/100BaseTX Select 100Mbps half-duplex mode.
/10BaseTFD Select 10Mbps full-duplex mode.
/10BaseT Select 10Mbps half-duplex mode.
/Disable_FlowControl Disable flow control function.
/slot=[1~f] Select the slot to work with.
METHOD 2:
---------
- If you want to run TC902XP.COM program, execute TC902XP.COM by typing:
>TC902XP [/option] <packet_int_no>
<packet_int_no> Software interrupt number
/w Windows mode
/d Delay initialize
/u Uninstall driver
/n NetWare conversion
/tx_buffers Set tx buffer number.
/rx_buffers Set rx buffer number.
/delaycounts Set send packet delay count(micro sec).
/autosense Performs Power-Up Autosense on all types of
boards in order to connect to the active line,
and dynamic 10/100 autosensing (at run-time)
on boards supporting it.
/100BaseTXFD Select 100Mbps full-duplex mode.
/100BaseTX Select 100Mbps half-duplex mode.
/10BaseTFD Select 10Mbps full-duplex mode.
/10BaseT Select 10Mbps half-duplex mode.
/Disable_FlowControl Disable flow control function.
/slot=[1~f] Select the slot to work with.
Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.