1. 8161b.exe Driver
2. README.TXT File Contents

README.TXT Driver File Contents (8161b.exe)

Follow these instruction to install the information file into Windows 95

Click on START
Select Settings
Select Control Panel
Select "Add New Hardware"
Select "Next"
Select "NO" to select the driver manually
Select "Next"
Select "Hard Disk Controllers"
Select "Next"
Select "Have Disk"
If you received a diskette with the driver on it, put the disk in the drive and select that drive letter and hit OK
If you Downloaded the driver, Browse and select the directory that you expanded the self extracting file WIN95DRV.EXE and select the file "LGE.INF" and select "OK"
You should have a choice of the two following controllers cards.
"GoldStar CD-ROM Controller (Acculogic Side - 2/CD)"
"GoldStar CD-ROM Controller (Future Domain IDE16000)"
Click on the model that you have installed
Select "Next" 
Select "Next"
Select "Finish"
Windows will ask you if you want to shut down, remove the floppy Disk and select YES
After the computer reboots, the drive should be present.

 **  If the drive is not present;
Double click System under Control Panel 
Click the "Device Manager" tab;
Click Hard Drive Controllers;
Double Click GoldStar CD-ROM Controller,(either Future Domain or Acculogic)
Click Resources tab and verify that the I/O ports and IRQ's settings in the resources setting box
are set according to the settings on the Interface Card.  Check the Conflicting Devices Llist to see what device is conflicting with the drive. If there is a conflict listed, change the Resource Setting by clicking the change setting button for each Resource Type.  Input the correct Resource Setting for the model card that you have; (see below) 

		Acculogic Side - 2/CD			Future Domain IDE16000

Interrupt Request		10					10
Input/Output Range	168  -  16F				160  -  167
Input/Output Range	36E  -  36E				366  -  366

Interrupt Request		15					15
Input/Output Range	170  -  177				170  -  17F
Input/Output Range	376  -  376				376  -  376

Interrupt Request		11
Input/Output Range	1E8  -  1EF
Input/Output Range	3EE  -  3EE

Interrupt Request		12
Input/Output Range	1E8  -  1EF
Input/Output Range	3EE  -  3EE

After changing Resource Setting for each Resource Type, shut down your system and change the jumper switches on your controller to reflect the changes you have made.  Start up system and drive should be present.

  *** If the DOS device drivers are loading in config.sys and autoexec.bat, remark the statements out to eliminate any conflicts in Windows 95.