[Msg] M0=Confirm M1=If it needs to correct fault? M2=The following CR# which store address of reading data (FROM instruction) is the same: M3=Channel 1 : OFFSET setting range should be M4=Channel 1 : GAIN setting range should be M5=Channel 1 : The result of (GAIN-OFFSET) should be M6=Channel 2 : OFFSET setting range should be M7=Channel 2 : GAIN setting range should be M8=Channel 2 : The result of (GAIN-OFFSET) should be M9=Channel 3 : OFFSET setting range should be M10=Channel 3 : GAIN setting range should be M11=Channel 3 : The result of (GAIN-OFFSET) should be M12=Channel 4 : OFFSET setting range should be M13=Channel 4 : GAIN setting range should be M14=Channel 4 : The result of (GAIN-OFFSET) should be M15=No action is selected M16=Conditional : M17=The address used to save data M18=Channel 5 : OFFSET setting range should be M19=Channel 5 : GAIN setting range should be M20=Channel 5 : The result of (GAIN-OFFSET) should be M21=Channel 6 : OFFSET setting range should be M22=Channel 6 : GAIN setting range should be M23=Channel 6 : The result of (GAIN-OFFSET) should be M24=Next M25=Normal frequency M26=Double frequency M27=Four times frequency M28=Up/down count is controlled by external input M29=Up/down count is controlled by register M30=DVP-04AD Analog Input Module M31=DVP-06XA Analog Input/Output Mixed Module M32=DVP-04TC Thermocouple Sensor (J/K Type) M33=DVP-04PT Platinum Temperature Sensor (PT100) M34=DVP-02DA Analog Output Module M35=DVP-04DA Analog output module M36=DVP-08RT Resistor Thermocouple M37=DVP-01HC High-Speed Counter Module M38=Please check the input setting of each channel that is relative to OFFSET and GAIN value M39=Setting range : M40=Setting range of input voltage mode : M41=Setting range of input current mode : M42=Does not set any parameter, exit this editor window or not ? M43=ELC-AN04ANNN Analog Input Module M44=ELC-AN06AANN Analog Input/Output Mixed Module M45=ELC-PT04ANNN Platinum Temperature Sensor (PT100) M46=ELC-AN02NANN Analog Output Module M47=ELC-TC04NANN Thermocouple Sensor (J/K Type)Download Driver Pack
After your driver has been downloaded, follow these simple steps to install it.
Expand the archive file (if the download file is in zip or rar format).
If the expanded file has an .exe extension, double click it and follow the installation instructions.
Otherwise, open Device Manager by right-clicking the Start menu and selecting Device Manager.
Find the device and model you want to update in the device list.
Double-click on it to open the Properties dialog box.
From the Properties dialog box, select the Driver tab.
Click the Update Driver button, then follow the instructions.
Very important: You must reboot your system to ensure that any driver updates have taken effect.
For more help, visit our Driver Support section for step-by-step videos on how to install drivers for every file type.