1. Netscan_20Firmware_201.1.exe Driver
2. sx-2000u2.inf File Contents

sx-2000u2.inf Driver File Contents (Netscan_20Firmware_201.1.exe)

[FILEINFO]
BINFILE1="sx2000u2.bin"

[WIZARD_BEGIN]
NEXT=ISLOADER;4;0

[WIZARD00]
TYPE=NORMAL
TITLE="Print configured information"
MESSAGE="Print the information configured in Device Server.\n\nWith the printer connected, hold down the button on the front of the printer for at least 5 seconds.\n\n\n\n*Depending on the model of the printer, the information may not be printed.\n*After recovering when an upgrade failed, continue without performing this operation."
BITMAP=P61_EEPPRINT.bmp
NEXT=JUMP;4
BACK=ENABLE
CANCEL=MESSAGE;Do you want to cancel?

[WIZARD04]
TYPE=NORMAL
TITLE="Start firmware upload"
MESSAGE="Start firmware upload.\n\n              << You can not cancel once you start. >>\n\nItems you need to verify before uploading firmware...\n\n* You will not be able to store the original version.\n* You may need to initialize/reset the configuration.\n\nUpload to be started when clicking [Upload] button."
BITMAP=default
NEXT=UPLOAD;BINFILE1;30;53
BACK=ENABLE
CANCEL=MESSAGE;Do you want to cancel?

[WIZARD30]
TYPE=NOTHING
NEXT=WAITSTANDBY;30;31;51

[WIZARD31]
TYPE=NOTHING
NEXT=SENDAPPMODE;32;32

[WIZARD32]
TYPE=NOTHING
NEXT=CHECKEEP;52;33

[WIZARD33]
TYPE=NOTHING
NEXT=SENDEEPCLR;52;51

[WIZARD51]
TYPE=NORMAL
TITLE="EEP Initialization"
MESSAGE="Firmware upload has been complete.\n\nYou need to initialize configuration for proper Device Server operation.\n\nTurn off Device Server, and then, with the button held down, turn the unit on again. Do not release the button until the indicator on the unit flashes twice.\n\nWhen this operation is completed, click [Next]."
BITMAP=P61_EEPCLR.bmp
NEXT=JUMP;52
BACK=DISABLE
CANCEL=DISABLE

[WIZARD52]
TYPE=NORMAL
TITLE="Upload is complete"
MESSAGE="Upload is complete now.\nRestart the Device Server."
BITMAP=default
NEXT=FINISH
BACK=DISABLE
CANCEL=INVISIBLE

[WIZARD53]
TYPE=NORMAL
TITLE="Failure with upload"
MESSAGE="Upload has failed by unexpected errors. Retry to upload from the beginning.\n\nNotice : The unit may not be detected when upgrading is performed again. If so, turn off Device Server, and then, with the button held down, turn the unit on again. Do not release the button until the indicator on the unit flashes once. If Device Server is correctly reset, the red indicator on the unit flashes for 1 second. At this time, try detecting the unit again."
BITMAP=P61_LMODE.bmp
NEXT=FINISH
BACK=DISABLE
CANCEL=INVISIBLE