1. SRBIOS04.EXE Driver
2. README.TXT File Contents

README.TXT Driver File Contents (SRBIOS04.EXE)

FLASH Memory Update Utility Release 3.5 
 
This utility is used to save and update FLASH memory. It is recommended 
that this utility be executed from a bootable MS-DOS diskette that 
contains BIOS recovery files for the target system (i.e. BIOS.REC). 
AUTOEXEC.BAT provide in this file set will execute the iflash utility.
 
This utility must be executed in a system without memory managers installed. 
If EMM386, QEMM, 386MAX, or Windows is active, then the FLASH update 
is not safe.  Remove any memory manager or exit Windows before executing 
the FLASH Memory Update Utility. 

NOTE !!!
All CMOS SETUP parameters will be lost during this process. If you have customer CMOS settings you wish to save, you must record them prior to running this update.

There are no options in this update process. Insert the update diskette containing the files unzipped from the downloaded file located on the Web site. Two updates will be observed during this update process. The BIOS update process will program the Boot Block followed by the system BIOS. 

CAUTION !!!   CAUTION !!!   CAUTION !!!   CAUTION !!!   CAUTION !!!   CAUTION !!!
Do not interrupt this process. The process is complete when you see the "CMOS Checksum Bad" error. You are not finished! Read the Update Process below. 
>>>>  Interrupting this process could render your system NOT Functional.  <<<<

Update Process:
1) Create the bootable DOS diskette with the files provided in this update. The autoexec.bat file provided in this update will run the update sequence automatically. The BIOS update process is complete when you see the "CMOS Checksum Bad" error. You are not finished! Read below. 

Set CMOS defaults (preferred method):
2) Remove the update diskette and Press F10 to set the new CMOS defaults.
3) The system is now ready to run your applications.

Alternate method to set CMOS if you have customer CMOS settings to enter after the update:
2) Remove the update diskette and Press the F1 key (instead of F10) to enter the CMOS SETUP utility after the BIOS update has completed. (You will enter the setup utility during normal operation by Pressing the F2 key during POST)
3) You must set the CMOS parameters to default values first by Pressing the F9 key.
4) Enter the customer settings after the default values have been set by Pressing the F9 key.
5) Press the F10 key to save all settings.